Fish Tank Lights

The idea of this project is to make lights for 30/10 gallons fish tank for relatively cheap or with items you already have.

Items needed:
3x 38-inch light strip of your choice. (30G)
3x 20-inch light strip of your choice. (30G)
38in x 2 in a piece of wood or metal. (10G)
20in x 2 in a piece of wood or metal. (10G)
2x M5 screws 30mm 
Hot glue 
Tape or carbon Vinyl
Led strip controller & power supply based on the led strip you are using.

Total Cost: $5

For this project, I used Fusion 360 to design two holders that will be attached to the edges of the tank that will hold the wood piece. 

Step 1:
Using the tape or carbon vinyl attach it to the wood piece. The reason I did that to make it easier to use hot glue to attach the light strip since it won't attach directly to the wood.
Step 2:
Attach the led strip to the wood piece using the hot glue. You can mix between RGB or Blacklight for this project.
Step 3
Attach the two holders to the side of the wood using the M5 screws. 
Step 4
Make sure everything is placed correctly and no wires hanging or touching the water. After that just slide the holders into the edges of the tank.